1.Enter the maintenance mode interface and select“Mode List”
2.Menu Selection“COPIER”
3.Menu Selection“Function”，Click“MISC-P”
4.Menu“MISC-P”Middle，Enter the second page interface
5.Select the "AT-IMG-X" button and then click "OK"
6.In operation interface
7.（1）Displaying 'OK' indicates that the machine has been adjusted properly and can be used normally （2）Displaying 'NG' indicates that the color sensor is dirty and needs to be cleaned. Cleaning operation Remove the transfer module, push open the black cover on the color sensor, clean the three small holes on the sensor with a leather blow, thoroughly clean the sensor inside the holes with a tissue, and then perform AT-IMG adjustment again.
12345671. Remove damaged or used fixing film from the fixing film component or fixing component.
2. Unscrew the cap of 2ml high-temperature oil bottle (see figure below).
3. Apply all the high-temperature oil evenly in the middle of the oil cloth of the pressure strip component, without leaving any high-temperature oil in the bottle. Follow the directions indicated in the diagram ①②③, and move steadily from the left to the right of the oil cloth to introduce the high-temperature oil (see Figure ④).
Picture①
Picture②
Picture③
Picture④
4. Install the fixing film onto the pressure strip component.
5. Rotate the fixing film several times by hand, and when you feel that the fixing film rotates smoothly, then assemble the fixing film component and the lower component.
Address：3rd Floor, Building A, Shangwei Village Industrial Park, Shangkeng Community, Guanlan Street, Longhua, Shenzhen, Guangdong
WeChat (Mr. He) 
WeChat (Mr. Song) 
Grace 
Zora 
CN